|
 |
|
 |
|
|
|
| |
Contact:Mr.Deng 18929104529 Mr.Zhou 18929169595
Miss Zhang 18929104530
Toll Free: 4000661106
Tel: 076921664818 (16 lines)
Fax: 076921664685
E-mail: ybl_kj@163.com
Website: http://www.dgybl.com
Address: Dongguan City Wanjiang Dafen Industrial Zone sand Kiln Lane 31, Lane ten |
|
|
|
|
|
|
![]() |
| Pneumatic cylinder, pneumatic supercharger turbo specific operation specification | Pneumatic cylinder, pneumatic supercharger turbo specific operation specification:
1 and in the air cylinder access road will be pressurized pipeline, must clean air, components, dust and debris.
2, in order to prolong the service life, ensure the cylinder cylinder seals, please use the normal use of dry, clean compressed air,
Again into the air in cylinder with effective air processing components (3) and add the lubricating oil and water treatment on time.
3 and the cylinder parts of components for iron, so not to use in a complex environment (chemical corrosive environment).
If you need in a complex environment, in order to use in our contact before are selected materials.
4 and the cylinder design for normal pressure, use of 0.3-0.7 MPa, if exceed the scope, must be in order
We are in contact, before the selected materials.
5 and when the cylinder design of temperature in the work environment for 0-60 ° c, if you need to use super temperature range, in order to us before
Department, specially selected materials.
6 and the selection of hydraulic cylinder design for medium VG68 # # # 46 or ISO, anti-wear hydraulic oil to switch to other liquid medium,
In order to contact us before, specially in SAP.
7 and control system should be based on hydraulic and pneumatic supercharging cylinder series product action programming.
Eight, the hydraulic and pneumatic supercharging series products according to the cylinder use frequency, high frequency 3 months replaced liquid medium (anti-wear hydraulic oil), usually make
8 months with frequency changing the liquid medium (anti-wear hydraulic oil).
9, to ensure that the pressurized cylinders work stability, suggest you as far as possible in the joint between the cylinder and installs a pressurized air storer, ensure
Air stability.
10 and as the output VAT in D intake, please check valve type with a fact. YBLI (with) in C exhaust series,
11 and the cylinder in replace hydraulic oil, must pay attention to the exhaust duct tape, and sundry raw, influence of the cylinder block into life. |
| | 【 Views：919 】 【 add time：2010-5-21 9:19:53 】 【 close 】 |
|
|
Liquid pressure cylinde- r series.jpg){kind=small}