|
|
|
|
|
|
|
|
Contact:Mr.Deng 18929104529 Mr.Zhou 18929169595
Miss Zhang 18929104530
Toll Free: 4000661106
Tel: 076921664818 (16 lines)
Fax: 076921664685
E-mail: ybl_kj@163.com
Website: http://www.dgybl.com
Address: Dongguan City Wanjiang Dafen Industrial Zone sand Kiln Lane 31, Lane ten
|
|
|
|
|
|
|
|
How high power transmission to the processing of the plane | Cutting mechanism of the pulse discharge still accord with electricity transmission principle, so the energy loss at least, molybdenum wire carrying electricity flow, and the current not least through any guide, ball screw, bearing, the impeller movement, these are important principles.
Usually workpiece is placed on the mat of insulation, cushion between the shoulders and lathe bed, the task of insulation insulation required here is very reliable. Through the power of positive transfer to the workpiece on the mat. Through the power of the anode block into electric wire frame relay to molybdenum wire, so into electricity block from processing centers in a relatively stable and not again recently in the processing of interference molybdenum wire the stable operation of the position. Into electricity block and lathe bed room also should be insulated. High frequency power to machined surfaces should be "into electricity channel, molybdenum wire, block the workpiece, cushion." Any other bypass the current through it will damage the mechanical parts, are not allowed, especially with the relative motion. In order to guarantee the frequency sampling closest to the machining gap, so the positive direct sampling in the mat, sampling negative to direct connect into electricity block in.
This article reprinted http://www.dgybl.com from (the), |
| 【 Views:762 】 【 add time:2010-9-1 17:32:24 】 【 close 】 |
|
|