|
|
|
|
|
|
|
|
Contact:Mr.Deng 18929104529 Mr.Zhou 18929169595
Miss Zhang 18929104530
Toll Free: 4000661106
Tel: 076921664818 (16 lines)
Fax: 076921664685
E-mail: ybl_kj@163.com
Website: http://www.dgybl.com
Address: Dongguan City Wanjiang Dafen Industrial Zone sand Kiln Lane 31, Lane ten
|
|
|
|
|
|
|
|
CNC lathe must use conditions | The normal use of CNC lathe must meet the following requirements, the position of the machine, the power supply voltage fluctuation little environmental temperature below 30 degrees Celsius temperature, relative to less than 80%.
A, machine tool position environmental requirements
The machine should be located away from the source, should avoid direct sunlight and thermal effect, avoid moisture and air. Such as machine near a source, anti-vibration shall set up around the machine. Otherwise it will directly affect the precision and stability of the machine, and will make contact, electronic components, affect the reliability of the machine.
Second, the power requirements. Lathe
General CNC lathe machining workshop, not installed in the ambient temperature changes, conditions of use, and all kinds of mechanical equipments, causing great power fluctuations. Therefore, the installation position of CNC lathe, need the power supply voltage is strictly controlled. The power supply voltage fluctuation must be within permitted, and maintain relative stability. Otherwise it will affect the normal work of the CNC system.
Third, lathe temperature conditions
The CNC lathe, environmental temperature below 30 Celsius temperature relatively less than 80%. Generally speaking, nc controls with internal platoon or cooling fan, to keep the electronic components, especially the CPU temperature constant temperature changes or work. High temperature and humidity control system components will lead to failure, and life. The temperature and humidity, increases in integrated circuit dust produced, and cause a short-circuit binder.
According to the instructions of the regulations, use tools
Users in the use of machine tool, not allowed to change control system of the parameters set factory. These parameters are directly related to the dynamic characteristics of the machine parts. Only the backlash compensation parameter values can be adjusted according to the actual situation.
Users can't replace machine tool accessories, such as the use of hydraulic chuck beyond specification stipulated. Factory in setting accessories, fully consider each link of the parameters matching. Cause all links replacement blind parameter mismatch, even than the accident caused an estimated.
Using hydraulic chuck, hydraulic turret, hydraulic pressure, hydraulic oil cylinder pressure, should be in the allowable stress range, don't allow any improvement.
This article reprinted http://www.dgybl.com from (the), |
| 【 Views:764 】 【 add time:2010-9-7 9:35:19 】 【 close 】 |
|
|