Homepage  |   Favorite   |   中文版                                  
Home page | Company profile | Product display | News Center | Organi zation | Plant equipment | Company philosophy | Manpower recruitment | Single system | Customer message | Contact Us | |
About Us
   
 
  Liquid pressure cylinde-
           r series
  Liquid booster series
  Gas booster series
  Press \ pressure punch
           series
  Solenoid valve \ pneuma-
           tic accessories series
  Times of Cylinder
  Other Products
 
 
Contact:Mr.Deng 18929104529
Mr.Zhou 18929169595
Miss Zhang 18929104530
Toll Free: 4000661106
Tel: 076921664818 (16 lines)
Fax: 076921664685
E-mail: ybl_kj@163.com
Website:http://www.dgybl.com
Address: Dongguan City Wanjiang Dafen Industrial Zone sand Kiln Lane 31, Lane ten
 
                     News Center
Presses safe operations
According to press a different machine types and processing requirements, to develop targeted, practical and safe operation, and the necessary job training and safety education. The use of units and the operator must strictly abide by the design and manufacture units to provide instructions for safe use regulations and operating procedures, proper use, maintenance. Press general safety operating requirements are as follows: First, the starting device, the control part of the press to check the clutch and brakes are in an efficient state, easy to use safety equipment is complete, the crank slider mechanism ministries without exception. Abnormality should immediately take the necessary measures, not sick, operation, demolition and damage the safety device is strictly prohibited. Second, the official shall be idle before the job test, confirmed only after the part of the normal work. Start cleaning up the table before all the unnecessary items, to prevent the car off the injured person or vibration impact caused by the slider switch suddenly started. Third, the operation must use tools, is prohibited by hand directly into his mouth extract mode, hand tools shall not be placed on the die. Fourth, adjust the mouth area in the mold workpiece position or get stuck in the mold exposing the workpiece, the feet must leave the foot pedals. Fifth, the people operating the same press should be a unified command, a clear signal until the other side to make a clear answer, and make sure to leave the danger zone further action. Sixth, the sudden loss of power should turn off the power or operation is completed, and the manipulator to return to neutral clutch, brake in a braking state. Seventh, to press for maintenance, adjustment and installation, adjustment, dismantling the mold should be disconnected at the machine energy (such as electricity, gas, liquid), the machine stops running under the circumstances, and the slider under the Placing Pad reliable support. Listed at the start switch machine warning notice.
(This article reproduced from http://www.dgybl.com)
【 Views:804 】 【 add time:2010-9-13 9:29:36 】 【 close

Copyright:Yalyce (DongGuan) Hydraulic Equipment Technology CO., Ltd Support:TXJNET 粤ICP备10081236号
Site Keywords:Liquid-drived Upower,Liquid-drived Booster,Pneumatic Press,Multiplier Air-Cylinder,Power Cylinder,half-arch